Puppy Linux Discussion Forum Forum Index Puppy Linux Discussion Forum
Puppy HOME page : puppylinux.com
"THE" alternative forum : puppylinux.info
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

The time now is Wed 01 Jul 2015, 01:01
All times are UTC - 4
 Forum index » Advanced Topics » Hardware » Audio
nm 256 on Omnibook 4150 working in puppy linux 2.16
Post_new_topic   Reply_to_topic View_previous_topic :: View_next_topic
Page 1 of 1 Posts_count_1  
Author Message

Joined: 12 Jul 2007
Posts: 7

PostPosted: Wed 18 Jul 2007, 11:30    Post_subject:  nm 256 on Omnibook 4150 working in puppy linux 2.16  

I did get sound working in the omnibook 4150 I found 3 drivers that will work to varying degrees the CS4232(one I chose) the cs4231 work relativly well,sound is softer than in Windows and you get cheated out of a master volume bar. I also got it to configure with a SB 8 analog driver but the output volume was terribly soft. For all these i ran the alsa config Utility built into puppy 2.16 seamonkey. Sometimes you do have to run the wizard a couple of times before it sees the card.
I then pasted these lines at the end of modules.conf
alias snd-card-0 snd-cs4232
alias sound-slot-0 snd-cs4232
options snd-cs4232 port=0x534 cport=0x538 mpu_port=-1 fm_port=0x388 irq=5 dma1=1 dma2=0 isapnp=0

and also replaced the alsa output in modprobe.conf with the same lines as it did not see the MPU port or FM port setting when it configured it.

Hope this helps some one

Back to top
View user's profile Send_private_message 
Display_posts:   Sort by:   
Page 1 of 1 Posts_count_1  
Post_new_topic   Reply_to_topic View_previous_topic :: View_next_topic
 Forum index » Advanced Topics » Hardware » Audio
Jump to:  

You cannot attach files in this forum
You can download files in this forum

Powered by phpBB © 2001, 2005 phpBB Group
[ Time: 0.0341s ][ Queries: 12 (0.0038s) ][ GZIP on ]