Joined: 21 Jun 2005 Posts: 52 Location: New Zealand
Posted: Sat 25 Jun 2005, 04:11 Post subject:
Need help booting Puppy from HD with floppy
Hi I am new to Puppy, I have got it up and running OK on one machine.
However I have been trying to get it going on an older Pentium that has no means of booting from a CD.
The machine works fine on Win 98se.
I have loaded the Three files vmlinuz, image.gz and usr_cram.fs and set up the Pupxide file as per instruction.
When I boot from boot2pup.img floppy that I created. It goes through the boot proceedure and it find the above files on C drive OK.
It seems to get a long way through the bootup process but then I get the following message "PCI: No IRQ known for interupt PIN C of device 00:0a.2
Please try using pci=biosrq. hcd.c Found HC with no IRQ. Check bios/pci 00:0a.2 setup
Now I do not know what to do next ??? where do I try and set pci=biosrq
Any suggestions would be most welcom
Many thanks in advance
Joined: 09 May 2005 Posts: 8283 Location: Perth, Western Australia
Posted: Sat 25 Jun 2005, 05:10 Post subject:
The floppy disk has the file "autoexec.bat", where you can add the "pci=".
I don't recall the exact content of the autoexec.bat file, but as I recall, tiny.exe was used, so there should be a line in there that starts with "tiny.exe ..... ".
-- insert your "pci=biosrq" at the end of that line.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum