How to use 802.1Q VLAN?
How to use 802.1Q VLAN?
Hi, anybody know how to get 802.1Q VLAN working on Puppy? I've searched Puppy forums and did not see anything. I can get this working ok with SUSE, but need several machines running live puppy with VLAN and iperf (iperf is no problem I have already)
What version of Puppy?
Have you tried to setup by using the Connection Wizard?
Have you tried to setup by using the Connection Wizard?
The things they do not tell you, are usually the clue to solving the problem.
When I was a kid I wanted to be older.... This is not what I expected
YaPI(any iso installer)
When I was a kid I wanted to be older.... This is not what I expected
YaPI(any iso installer)
I was not able to use the ip command in busybox to set up vlans. Had to do it the old way instead...
get vconfig here:
http://www.candelatech.com/~greear/vlan/vlan.1.9.tar.gz
I use the following vlan_startup script in /etc/rc.d/init.d This sets up 2 vlans
vlan 3 is private
vlan 2 is used as the the default interface
...edit it for your needs and in "Puppy Setup/Configure Startup of Puppy/Choose which system/services to run at startup" check vlan_startup
#!/bin/bash
# 12/30/11 jharragi@mw.k12.ny.us
# requires vconfig - from http://www.candelatech.com/~greear/vlan.html
# you only need one file (vconfig) from the newest release tarball
# copied to /usr/local/bin
ifconfig eth0 0.0.0.0 up
vconfig add eth0 2
vconfig add eth0 3
ifconfig eth0.2 29.22.42.6 broadcast 29.22.42.255 netmask 255.255.255.0 up
ifconfig eth0.3 10.0.3.40 broadcast 10.0.3.255 netmask 255.255.248.0 up
route add default gw 29.22.2.1 dev eth0.2
get vconfig here:
http://www.candelatech.com/~greear/vlan/vlan.1.9.tar.gz
I use the following vlan_startup script in /etc/rc.d/init.d This sets up 2 vlans
vlan 3 is private
vlan 2 is used as the the default interface
...edit it for your needs and in "Puppy Setup/Configure Startup of Puppy/Choose which system/services to run at startup" check vlan_startup
#!/bin/bash
# 12/30/11 jharragi@mw.k12.ny.us
# requires vconfig - from http://www.candelatech.com/~greear/vlan.html
# you only need one file (vconfig) from the newest release tarball
# copied to /usr/local/bin
ifconfig eth0 0.0.0.0 up
vconfig add eth0 2
vconfig add eth0 3
ifconfig eth0.2 29.22.42.6 broadcast 29.22.42.255 netmask 255.255.255.0 up
ifconfig eth0.3 10.0.3.40 broadcast 10.0.3.255 netmask 255.255.248.0 up
route add default gw 29.22.2.1 dev eth0.2