sharing a internet signal through a router is simple with windows but how do i set up with puppy?
im getting the signal from a neighbor which i wish to resend out my eth to my router which is wireless.i have the dhcp turned off on the router i know how to set all that up.also i am getting a good signal wireless.i just dont know how to do the settings to share.or if i have to bridge or download something.
any advice may help thanks.
get signal through wlan resend out eth to router?
You need to set network as a bridge
I can only find info for bridging out on wifi....I don't know if you can figure it out from that?
http://murga-linux.com/puppy/viewtopic.php?t=67886
http://www.murga-linux.com/puppy/viewtopic.php?t=68127
bridgeutils.pet d/l
http://www.murga-linux.com/puppy/viewto ... h&id=41195
else tldp - a bit more complex....?
http://tldp.org/HOWTO/Ethernet-Bridge-n ... WTO-3.html
HTH
Aitch
I can only find info for bridging out on wifi....I don't know if you can figure it out from that?
http://murga-linux.com/puppy/viewtopic.php?t=67886
http://www.murga-linux.com/puppy/viewtopic.php?t=68127
bridgeutils.pet d/l
http://www.murga-linux.com/puppy/viewto ... h&id=41195
else tldp - a bit more complex....?
http://tldp.org/HOWTO/Ethernet-Bridge-n ... WTO-3.html
HTH
Aitch
would think this is all i need:
rm -f /var/lib/dhcpcd/*.info
rm -f /var/run/*.pid
ifconfig wlan0 0.0.0.0 up
ifconfig eth0 0.0.0.0 up
modprobe bridge
brctl addbr br0
brctl addif br0 wlan0
brctl addif br0 eth0
however it just isnt working the bridge comes on.do i need to be putting ip numbers or something where the zeros are? example ifconfig wlan0 192.168.1.11up
because all i did was paste those two codes in the terminal as is.and sure the results give me the bridge choice in wizard.but then i click dhcp.all is fine.i plug in my router and loose internet.
btw my dchp on the router is turned off.
rm -f /var/lib/dhcpcd/*.info
rm -f /var/run/*.pid
ifconfig wlan0 0.0.0.0 up
ifconfig eth0 0.0.0.0 up
modprobe bridge
brctl addbr br0
brctl addif br0 wlan0
brctl addif br0 eth0
however it just isnt working the bridge comes on.do i need to be putting ip numbers or something where the zeros are? example ifconfig wlan0 192.168.1.11up
because all i did was paste those two codes in the terminal as is.and sure the results give me the bridge choice in wizard.but then i click dhcp.all is fine.i plug in my router and loose internet.
btw my dchp on the router is turned off.
well i got this to get the job done instead
http://www.murga-linux.com/puppy/viewtopic.php?t=37520
http://www.murga-linux.com/puppy/viewtopic.php?t=37520
http://www.murga-linux.com/puppy/viewtopic.php?t=37520
http://www.murga-linux.com/puppy/viewtopic.php?t=37520