PCMCIA-Card (XIRCOM Credit Card Ethernet 10/100) is correctly detected (checked with "cardctl ident") and the appropriate driver is loaded ("lsmod").
When using the networkwizard, there's only the option, to add a driver or EXIT, the buttons to test or configure the network are missing.
Any idea, how to go further ? (Hardware is ok, works with other distributions and Win...)
Network configuration problem (Puppy-1.0.4 with XFree 4.5.0)
mmmmm If you had of looked at the file....
but here you go
change this line to as follows
And that's all you need to do
but here you go
Code: Select all
# Network adapter configuration
#
# The address format is "scheme,socket,instance,hwaddr".
#
# Note: the "network address" here is NOT the same as the IP address.
# See the Networking HOWTO. In short, the network address is the IP
# address masked by the netmask.
#
case "$ADDRESS" in
*,*,*,*)
INFO="Sample private network setup"
# Use this to override the interface name -- see 'man nameif'
NAMEIF=""
# Transceiver selection, for some cards -- see 'man ifport'
IF_PORT=""
# Use BOOTP (via /sbin/bootpc, or /sbin/pump)? [y/n]
BOOTP="n"
# Use DHCP (via /sbin/dhcpcd, /sbin/dhclient, or /sbin/pump)? [y/n]
DHCP="n"
# If you need to explicitly specify a hostname for DHCP requests
DHCP_HOSTNAME=""
# Host's IP address, netmask, network address, broadcast address
IPADDR=""
NETMASK="255.255.255.0"
NETWORK="10.0.1.0"
BROADCAST="10.0.1.255"
# Gateway address for static routing
GATEWAY="10.0.1.1"
# Things to add to /etc/resolv.conf for this interface
DOMAIN=""
SEARCH=""
DNS_1=""
DNS_2=""
DNS_3=""
# NFS mounts, should be listed in /etc/fstab
MOUNTS=""
# If you need to override the interface's MTU...
MTU=""
# For IPX interfaces, the frame type and network number
IPX_FRAME=""
IPX_NETNUM=""
# Extra stuff to do after setting up the interface
start_fn () { return; }
# Extra stuff to do before shutting down the interface
stop_fn () { return; }
# Card eject policy options
NO_CHECK=n
NO_FUSER=n
;;
esac
Code: Select all
# Use DHCP (via /sbin/dhcpcd, /sbin/dhclient, or /sbin/pump)? [y/n]
DHCP="y"