@rcrsn51
1. "
Did the MTP window open in ROX or do you have ROX linked so it opened in Xfe?"
a. When I run CamPhoneTab,..
I click the MTP radio button and then click "connect"...
An "sh" window opens saying:
Code: Select all
Leave this window open ... use ROX Rescan if needed ...
2016/01/14 18:14:53: Connected.
And...
b. No file explorer auto-runs.
Normally, I would manually run a chosen File Explorer...
Either ROX or Xfe, and then navigate to /mnt/CamPhoneTab...
But I now notice that I can click "View" in CamPhoneTab, and that will open a ROX window displaying /mnt/CamPhoneTab...
[I deliberately have ROX set as the default, not Xfe; there's a good reason which I have now forgotten]
However...
c. When I now do one of these...
The /mnt/CamPhoneTab folder is EMPTY!
I made sure the phone was plugged in and powered on prior to running CamPhoneTab.
d. It worked fine the 1st time, when...
d1. I booted into a session...
d2. Installed CamPhoneTab-1.1.10
d3. Connected the phone.
d4. Ran CamPhoneTab, clicked MTP, clicked Connect.
d5. Ran ROX and/or Xfe, navigated to /mnt/CamPhoneTab, and could see the "Pictures" folder, with its sub-folders, and could copy content from there to my internal HDD.
2. "
Can you manage the files on the MTP device directly from Xfe?"
a. When it worked I could.
i.e. The 1st time I installed it.
I didn't save the session changes at the end of that [1st] session [to avoid saving other stuff I didn't want].
Instead, I rebooted without saving, and installed once again during the next [2nd] session, then SAVED the session changes, and closed down [this was the only change made during the session].
b. When I next booted [into the 3rd session = this one] I'm finding that the /mnt/CamPhoneTab folder is displaying NOTHING [empty].
Same [empty] in ALL = ROX, Xfe, and "View" in CamPhoneTab->[ROX].
3. I do remember, that...
There was a session [the 1st?] that FROZE after I installed CamPhoneTab, and I used Ctrl+Alt+backspace, then reboot.
Hence, no saved session changes.
4. Any ideas?