(old)Puppy Linux Discussion Forum

I use adsl-setup to config my adsl-network.
After it run adsl-start. It says that connected!
But i can't see any webpage in Mozilla, I can't download my e-mails, etc.

What should i do?

I use puppy 1.0.4 in a Multisession CD-R...

Have you tried the Ethernet wizard?

Start->Setup->Ethernet/network wizard?

This will correctly (well, has always worked for me) setup your ethernet interface, eth0

I'm using Bellsouth ADSL and the ethernet wizard worked fine for me. I can also use my 5 port wired network.

Ethernet wizard doesn't work for me. I don't know why...
I have a surecom ep 320-s PCI ethernet card (MYSON technology)
The fealnx driver is loaded, so it should be work, but i become the message that ethernet wizard doesn't find any connactable network or something like this. But after it I can connect with adsl-setup and adsl-start, so I think that it works... Maybe the DNS not good. I wanted to edit /etc/resolv.conf file but i can't. I see an error icon in ROX at this file.

Sorry for this very bad english... I hope that it's undersandable..

Please help me somebody! I have yet the same Problem with Puppy 1.0.5
What should I do? adsl-setup works, also adsl-start, but i can't communicate with internet, e-mail, etc...
These drivers are loaded: felnx, ppp_generic.
Should i load any other driver for adsl?
Or should i edit the resolv.conf file? (I can't do this)

Give the dns-servers. Worked for me.

Where should I edit the dns-servers???
And what should i type in?

- run adsl-setup in a terminal:
# adsl-setup
- give your username
- give your interface (I accepted default)
- give dns (I did a Google-search for the dns-servers of my isp)
>>> Enter the DNS information here: 99.99.99.99
- give secondary dns (or you can give the primary dns again)
>>> Enter the secondary DNS server address here: 99.99.99.99
- give your pppoe-password twice
- give type of firewall
- accept
- start connection
# adsl-start

Thank you gowish! I will probe that at afternoon, when i come home.
But in other distribution always had work, when i type hier "server".

And for me that ppp roar penguin (or what) also doesn't work.

See this message please:

http://www.murga.org/%7Epuppy/viewtopic.php?t=2628

Mark

Thanks again gowish! It works! Mu! I think, what gowish say is the easiest way. You should try too.

Can we say that this problem is solved?

Yes! We can say, that this problem is solved! I write this post under Puppy. So it works perfectly.