Hi i installed puppy 1.0.6 to the hard drive and then tried installing the xi810 driver rom pupget. after install it says to reboot jwm before the menu will show. i have done that no option shows up. reboot the system sets at the #
without starting xwin. typing xwin ends up not starting. this isthe thrid time i have reinstalled in order to get to the starting point again......
pupget Xi810 reboot xwin problem
pupget Xi810 reboot xwin problem
I don't want to GUI the world.. Just my life...
Hi,
You will have a symbolic link pointing to Xfbdev or so.
Check that:
cd /usr/X11R6/bin/
ls -al X*
If my suggestion is correct, try this:
rm -f /usr/X11R6/bin/X
ln -s /usr/X11R6/bin/Xvesa /usr/X11R6/bin/X
Then the vesa-driver should work again.
In the board we had several people reporting the i810-chipset works very well with the x.org-Xserver: http://www.murga.org/%7Epuppy/viewtopic.php?t=2303
The fbdev-driver you have in Pupget just seems to work on some Graficscards with that chip.
Mark
You will have a symbolic link pointing to Xfbdev or so.
Check that:
cd /usr/X11R6/bin/
ls -al X*
If my suggestion is correct, try this:
rm -f /usr/X11R6/bin/X
ln -s /usr/X11R6/bin/Xvesa /usr/X11R6/bin/X
Then the vesa-driver should work again.
In the board we had several people reporting the i810-chipset works very well with the x.org-Xserver: http://www.murga.org/%7Epuppy/viewtopic.php?t=2303
The fbdev-driver you have in Pupget just seems to work on some Graficscards with that chip.
Mark