skype 4.3.0.37
I can hear sound but it will skype will not identify or use my Microsoft Lifecam 2000 microphone.
I see that there is a pulse sound interface and puppy must use it some to enable the sound to be heard. But I don't see any way of directing pulse to interface with my microphone source.
Thanks.
skype and Tahr puppex 6.03 32 bit
Are you using the apulse skype in quickpet or a pulseaudio skype? How did you install skype? If you use a pulseaudio skype as explained here:
http://www.murga-linux.com/puppy/viewto ... 153#892153
then you should change in /etc/pulse/default.pa the following lines:
or maybe:
depending on your hardware.
EDIT: type in console:
to see the right mic device.
http://www.murga-linux.com/puppy/viewto ... 153#892153
then you should change in /etc/pulse/default.pa the following lines:
Code: Select all
load-module module-alsa-sink device=hw:1,0
load-module module-alsa-source device=hw:1,0
Code: Select all
load-module module-alsa-sink device=hw:1,0
load-module module-alsa-source device=hw:2,0
EDIT: type in console:
Code: Select all
arecord -l
no default.pa to reference just conf file a screenshot of which is attached as pulse2.png
the arecord -l screen is also attached pulse1.png
Please advise and thanks for your help in advance.
the arecord -l screen is also attached pulse1.png
Please advise and thanks for your help in advance.
- Attachments
-
- pulse2.png
- (116.13 KiB) Downloaded 415 times
-
- pulse1.png
- (35.21 KiB) Downloaded 437 times
I am ignorant of your case. I think you are using the apulse skype in quickpet. I would try to change the line in /etc/pulse/client.conf:
in:
(be careful to delete the semicolon at the beginning of the line...). I cannot say more. Wait for more skilled help.
Code: Select all
;default-source=
Code: Select all
default-source=hw:2,0
I did some tests in a live session of tahr 6.0.5 and I have successfully used the pulseaudio skype with the webcam mic. I do not know how to achieve this result with the apulse skype but I can explain what I did in my case.
Follow the installation of the pulseaudio skype as explained at:
http://www.murga-linux.com/puppy/viewto ... 153#892153
Use in /etc/pulse/default.pa:
(these settings are for auricolar and the webcam mic card 2)
Install the pavucontrol-test.pet at:
http://www.murga-linux.com/puppy/viewto ... 321#844321
Open a console and type:
Then launch Pulseaudio Volume Control from Multimedia menu and go to input tab; tick and untick for deactivating and activating the webcam mic. Then launch:
Make a test call. It worked for me. Note that it is possible the need to run fixmenus and restart X to see the new softwares in the menu.
Follow the installation of the pulseaudio skype as explained at:
http://www.murga-linux.com/puppy/viewto ... 153#892153
Use in /etc/pulse/default.pa:
Code: Select all
load-module module-alsa-sink device=hw:1,0
load-module module-alsa-source device=hw:2,0
Install the pavucontrol-test.pet at:
http://www.murga-linux.com/puppy/viewto ... 321#844321
Open a console and type:
Code: Select all
pulseaudio --start
Code: Select all
skype4.3