Puppy Linux Discussion Forum Forum Index Puppy Linux Discussion Forum
Puppy HOME page : puppylinux.com
"THE" alternative forum : puppylinux.info
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

The time now is Wed 01 Jul 2015, 08:56
All times are UTC - 4
 Forum index » Advanced Topics » Hardware » Networking » Ethernet
Xircom RBEM56G-100 setup
Post_new_topic   Reply_to_topic View_previous_topic :: View_next_topic
Page 1 of 1 Posts_count  
Author Message

Joined: 07 May 2009
Posts: 4
Location: Morgantown,West Virginia

PostPosted: Fri 08 May 2009, 12:05    Post_subject:  Xircom RBEM56G-100 setup
Sub_title: Can't seem to get the right module???

I have a used but confirmed working Xircom RBEM56G-100 PCMCIA ethernet adapter running latest Puppy LiveCD and trying to test the machine out but can't seem to get any modules loaded to allow me to use the ehternet card mentioned.

Any suggestions?

Laptop is a Gateway Solo 9300, 288mb RAM, working on the hard drivwe but thats another story....
Back to top
View user's profile Send_private_message 

Joined: 04 Apr 2007
Posts: 6822
Location: Chatham, Kent, UK

PostPosted: Tue 12 May 2009, 00:00    Post_subject:  

try either the pcmcia-cs driver or tulip driver in the network wizard

that pcmcia device is known buggy



unplugging the card after bootup may help, as it may be a timing problem, which has been common, not loading the driver early enough

dougal is the puppy network guru, so pm him

Aitch Smile
Back to top
View user's profile Send_private_message 
Display_posts:   Sort by:   
Page 1 of 1 Posts_count  
Post_new_topic   Reply_to_topic View_previous_topic :: View_next_topic
 Forum index » Advanced Topics » Hardware » Networking » Ethernet
Jump to:  

You cannot attach files in this forum
You can download files in this forum

Powered by phpBB © 2001, 2005 phpBB Group
[ Time: 0.0358s ][ Queries: 11 (0.0029s) ][ GZIP on ]