PCTel HSP56 dialup modems
Posted: Wed 21 Dec 2005, 13:35
One more dialup modem question for today...
I use Puppy on six different computers regularly, and it works brilliantly on all of them (except for one weird problem). Naturally that means that I run into a lot of dial up modems too.
So far I've found solutions for HCF/HSF modems, Broadcom modems, and the usual SmartLink and Lucent modem packages, two of them thanks to the great folks on this forum.
However, I'm stumped now with a PCTel PCI card modem. The PCI ID is 134d:2189, which corresponds to a PCTel HSP56 modem. ScanModem can't even find the modem on the PCI bus. I tried downloading pctel.zip from here, but the pre-compiled pctel.o module refuses to load (even insmod -f complains and drops out) and one can't compile things in puppy... or am I wrong about that?
All the other pctel drivers out there also appear to need to be compiled, so wanted to ask if anyone's had any success otherwise.
I use Puppy on six different computers regularly, and it works brilliantly on all of them (except for one weird problem). Naturally that means that I run into a lot of dial up modems too.
So far I've found solutions for HCF/HSF modems, Broadcom modems, and the usual SmartLink and Lucent modem packages, two of them thanks to the great folks on this forum.
However, I'm stumped now with a PCTel PCI card modem. The PCI ID is 134d:2189, which corresponds to a PCTel HSP56 modem. ScanModem can't even find the modem on the PCI bus. I tried downloading pctel.zip from here, but the pre-compiled pctel.o module refuses to load (even insmod -f complains and drops out) and one can't compile things in puppy... or am I wrong about that?
All the other pctel drivers out there also appear to need to be compiled, so wanted to ask if anyone's had any success otherwise.