(old)Puppy Linux Discussion Forum

Posted: **Sat 19 Dec 2009, 07:08**

Hi all. I have an old OQO v01 that has the Atmel AT76C505A chipset and I can't seem to get it going with Puppy 4.3.1. Puppy doesn't detect it on boot and manually installing the module (at76c50x-usb) doesn't work either. Anyone with any ideas on how to troubleshoot this further? Thanks in advance for any help.

Posted: **Sat 19 Dec 2009, 08:46**

It's necessary to identify your device number.
Plug in your USB device, then run this command

Code: Select all

cat /proc/bus/usb/devices

then report the "Vendor" and "ProdID" values for the wifi device.
Please keep your response to this forum thread.

Posted: **Wed 23 Dec 2009, 01:46**

grash,
we get a lot of dead-end queries on this forum.
Was the answer more complex than you had presumed/wished?
Or did your request for help suddenly drop in priority?