Page 1 of 1

slmodem NO IRQ

Posted: Tue 07 Jun 2005, 20:34
by gbg
Hello everyone!

Finally PUPPY runs on MY computer (Siemens Fujitsu Amilo)!!!
Cool...almost -> The modem does not work and I am writing this message from Win2K :-/

Once I've run the modem wizard, the following message is shown:

"PCI Modem
Bus 0, device 17, function 6
Communication Controller: VIA Technologies, Inc. Intel 537 [AC97 Modem] rev 128
vendor chip 1106:3068"

-> once I've chosen ttySL0
"FAIL /dev/ttySL0 does not seem to have an irq assigned
There is probably nothing on that port so try another...

SUCCESS, /dev/ttySL0 seems to be a modem, using irq=
..."

-> and finally the Xproc-System information gives me the following info:
"Bus 0, device 17, function 6:
Communication Controller: VIA Technologies, Inc. Intel 537 [AC97 Modem] (rev 128)
IRQ5 I/O at =xdC00 [=xdcff]"


-->> funny...why do here get an irq when the modem wizard does not find one...?

-->> is the missing IRQ responsible for the modem not connecting to the net?

Any help is welcome!

Regards,
Oliver

Posted: Tue 07 Jun 2005, 20:49
by Rich
I've just tried that on my system and discovered something that is probably no use, but might help find the solution for you.

If I run the modem wizard, it picks out my modem ok. BUT, if I run it while connected to the net, I get exactly the same error message that you did, even though it's obviously working. Not sure why a working and connected modem should come up with an error like this though.

( just read this one back.......it's no help at all.........sorry ! )

Rich

Posted: Thu 09 Jun 2005, 15:20
by BarryK
There could be some differences due to the 2.6 versus 2.4 kernels.
Try Pup 1.03, let us know what happens.

Posted: Sat 11 Jun 2005, 18:58
by gbg
Hi everyone,

with puppy 1.03 I'm back where I was before v1.02:
--> no boot for puppy on my laptop...kernel 2.4 has problems with the USB :-(
I was very happy with k2.6 regarding my USB hardware recognition, with k2.4 the modem problem might be sorted out but I can't test it because of some IRQ problems during booting ... there's already some postings in the old forum on this issue.

Is the only solution a puppy 1.03 unleashed (k2.06)?


Regards,
Oliver