Puppy Linux Discussion Forum

[dialeddown]

Hello.

Puppy 4.3.1 pupdial says no modem detected. Trying every probe and button maybe more than once gets one help section to say one or two modems detected (I only have the winmodem) and mentions cdc_acm I think. However, the main pupdial window still says no modem detected. At some point, I think lsmod showed agrmodem and agrserial but no change to pupdial.

I read on another website that the current puppy ran agere and I would like to run this modem.

Thank you.

SCANMODEM RESULTS

Modem chipset detected on
NAME="Audio device: Intel Corporation 82801H "
CLASS=0403
PCIDEV=8086:284b
SUBSYS=1025:0133
IRQ=22
HDA=8086:284b
SOFT=8086:284b.HDA
HDAchipVendorID=11c1
CHIP=0x11c11040
CodecClass=14f1
IDENT=agrsm
Driver=agrsm

For candidate modem in: 00:1b.0
0403 Audio device: Intel Corporation 82801H
Primary device ID: 8086:284b
Subsystem PCI_id 1025:0133
Softmodem codec or chipset from diagnostics: 0x11c11040
from Archives:
The HDA card softmodem chip is 0x11c11040

[FrankA]

for 11c1:1040 agere Delphi D40 AC'97 softmodem there are drivers around but it is somewhat difficult to get them running also if they do performance might not be so stable.

[peebee]

Please see
http://www.murga-linux.com/puppy/viewtopic.php?t=44376
for a report of this modem working
Cheers
Peter

[dialeddown]

Wary 510 worked and other versions might work.

The auto-detection worked as far as it could but remember that some conf settings depend on your location for dialing rules (phone numbers to get a carrier) and your ISP login for whether to use stupid mode or not.