I can't install my printer in CUPS in Tahrpup 6.0.5. I have installed in Lucid Puppy 5.2.8.7 and followed a similar procedure here but without success. The difference seems to have to do with the absence of a parallel port option in Tahrpup 6.0.5. My printer is HP Laserjet 5L. I can find it and select the Gutenberg driver but nothing prints.
I have scrolled through the discussion pages but not found a solution.
I could go back to Lucid but I have begun to like Tahrpup.
Thanks
gusfagan
CUPS in Tahrpup 6.0.5
I can confirm that Tahrpup, at least in 602, is missing the kernel modules that auto-detect parallel printers. [Edit] See the clarification below.
You can manually install them with the command "modprobe lp".
But I am confused by your statement:
You can manually install them with the command "modprobe lp".
But I am confused by your statement:
How can you find it if CUPS does not show you a parallel port device?I can find it and select the Gutenberg driver but nothing prints.
Last edited by rcrsn51 on Sun 10 Jul 2016, 18:44, edited 1 time in total.
I remember the following discussion which can come useful:
http://murga-linux.com/puppy/viewtopic. ... 599#850599
http://murga-linux.com/puppy/viewtopic. ... 599#850599
CUPS in Tahrpup6.0.5
Thanks to everyone for the suggestions. Selecting the parallel port driver in Qiickpet didn't work because nothing happened when I clicked on it. Entering 'modprobe lp' in the console did the trick.
End of topic.
gusfagan
End of topic.
gusfagan
Just to be clear, this isn't really a kernel module problem - it's the ability to have the modules auto-loaded so parallel-port printing works seamlessly.
This used to work in old Puppies and I suspect that the CUPS daemon did the loading. Now you need to load the lp module yourself. You will probably need to do this at every boot, so put the line "modprobe lp" in the file /etc/rc.d/rc.local.
The ppdev module is handy because it identifies the vendor/model of the printer, like what happens with USB printers. It's optional and you only need it once, when you install the printer in CUPS.
This used to work in old Puppies and I suspect that the CUPS daemon did the loading. Now you need to load the lp module yourself. You will probably need to do this at every boot, so put the line "modprobe lp" in the file /etc/rc.d/rc.local.
The ppdev module is handy because it identifies the vendor/model of the printer, like what happens with USB printers. It's optional and you only need it once, when you install the printer in CUPS.
CUPS in Tahrpup 6.0.6
Thanks. Putting 'modprobe lp' in the etc/rc.d/rc.local has resolved the problem.
gusfagan
gusfagan