"Link quality 0, Signal level 0" Problem

[mjclark]

Hi! I'm trying to configure my Belkin Wireless-G PCMCIA card with PupFlux.
The card is detected and in turn scans and detects wireless networks, but whether it's a secure network (and i enter the WEP key correctly and set IP either by DCHP or static method) or an unsecured open network, iwconfig always returns a "link quality 0, signal strength 0" message and I can't connect to the internet.
Please help!

[darkcity]

the second post of this thread may help, although it involves using Wary

http://murga-linux.com/puppy/viewtopic.php?t=71513

[mjclark]

Thanks! The guy in that thread has got link and signal values though and those are the steps i've been going through with the network wizard everytime.
This networking can be tricky eh?

[darkcity]

it seem strange that the signal level is 0 but it is there.

my only other suggestions are trying the command line,
instruction here-

http://www.murga-linux.com/puppy/viewtopic.php?t=22469

or maybe at a long shot try Frisbee