Puppy Linux Discussion Forum

[cthisbear]

Try this instead....from Iguleder. ..Kinda Lucid Puppy 006

http://murga-linux.com/puppy/viewtopic.php?t=57371

I tried this on my little Acer netbook when kinda lucid was released.

Wireless worked perfectlt with encyption.

Pwireless 2
Network Wizard >> Dougal
Simple Network
Network Wizard Classic >> Barry

My review.

http://murga-linux.com/puppy/viewtopic.php?t=67859

And use my latest April 2011 technique.if it won't work with Pwireless2.

http://www.murga-linux.com/puppy/viewtopic.php?t=66936

And quite honestly why not try Wary?

And did you post your specs?????

Chris.


Chris.

[muggins]

Your frustration is understandable but it's important, in fault-finding, to let us know exactly what you've done. You've installed an 8192cu pet, but don't say whether it was the one by Pemasu for Exprimo, or the one compiled by Tempestuous, for Lucid, which uses a completely different kernel.

After install, did you reboot?

I'm still not sure what you're actual device is...could you perhaps give a link to the product's page?

Have you run Menu>Setup>Internet Connect Wizard? (I'm guessing you would tryInternet by wired or wireless LAN)

[tempestuous]

[danxaz]

Ok here are some details:

My system is an Old IBM Thinkpad:

Intel Celeron 550 Mghz
128 Mb Ram
30G Hard Rive
Currently running Windows XP, but very slowly. The wirelss USB Adapter works fine on XP.

The USB Adapter is a mini usb type:

Realtek RTL8188CU 802.11n
It came with a cd that has drivers for Windows, Mac, and Linux

There is a lot of information about Linux on the disk as well as a power point slide show that has instructions but it has a lot of information about teminal prompts and "building" etc. ??

There are files that end in .tar that I think are the drivers but I don't know what to do with them.

[tempestuous]

Your information still doesn't tell us the Puppy version with which you attempted to install the 8192cu driver.

[danxaz]

I've tried a few different versions of Puppy on this system and so far the only one I've got to work it 4.3. That's what I'm trying it with.

[danxaz]

[quote="muggins"]Your frustration is understandable but it's important, in fault-finding, to let us know exactly what you've done. You've installed an 8192cu pet, but don't say whether it was the one by Pemasu for Exprimo, or the one compiled by Tempestuous, for Lucid, which uses a completely different kernel.

I installed the one from Pemasu

[danxaz]

[danxaz]

I will try rebooting again.

[pemasu]

I suppose you installed dpup exprimo 5.X.13 which uses kernel 2.6.39.4 and used the 8192cu I did upload. Since that my uploaded driver works only in dpup exprimo. I just wanted to clarify that.

[danxaz]

Thats the one.