Compaq Presario mplayer (375MHz AMD-K6 3D) worked for a few months then
suddenly "cannot open audio device /dev/dsp" "unable to set hw
parameters" same as with my DELL D600 (see a previous posting).
Downloaded xine which does work (as does gxine in puppy 4.3.1). Same
problem with a fresh installation of pulp01. I am guessing something
changed in the hardware that this mplayer cannot handle but xine can.
Should I try a later mplayer than 1.0pre8? Where to look for one?
mplayer stopped working on Presario 1200
mplayer problem is in pulp linux
This posting was supposed to be in pulp linux, which comes with mplayer.
I had described a similar problem for a DELL Inspiron D600.
Has mplayer refused to work for anyone in another derivative of puppy?
I had described a similar problem for a DELL Inspiron D600.
Has mplayer refused to work for anyone in another derivative of puppy?
mplayer working again
I have no idea what changed to make it work.