Page 1 of 1
Guvcview 1.6.1
Posted: Sat 10 Nov 2012, 20:50
by walter leonardo
Hello someone can compile guvcview-1.6.1 for Wary 5.3?
Re: Guvcview 1.6.1
Posted: Sat 10 Nov 2012, 21:43
by rcrsn51
walter leonardo wrote:Hello someone can compile guvcview-1.6.1 for Wary 5.3?
Are you aware of guvcview-1.5.0
here? There are significant problems with building guvcview in older Puppies past this point.
Posted: Sun 11 Nov 2012, 00:15
by walter leonardo
I did not know, thanks and sorry.
Posted: Sun 11 Nov 2012, 00:53
by walter leonardo
report error in wary 5.3.90
Posted: Sun 11 Nov 2012, 01:43
by rcrsn51
Did you install both packages? I tested it in Wary 5.3 with two different webcams and guvcview worked. But it may not be compatible with all devices.
I did not test it in 5.3.90.
[Edit] I checked in Wary 5.3.90 and guvcview worked there too. Try the following command. Does it wake up your webcam?
Posted: Sun 11 Nov 2012, 19:51
by walter leonardo
If you install the two packages. Now if I work well, but some programs like Mplayer and Ogle DVD not working. It will be up to check the dependencies. Thank you!!!
tested in RACY 5.3.90
Posted: Wed 16 Jan 2013, 01:40
by hikohan
Test report in RACY 5.3.90 .
works great!! after both packages install, run gucview and video/image capture smoothly.
Thanks for your help!!
1.5.0 not works in Precise 5.4.3
Posted: Thu 24 Jan 2013, 03:02
by hikohan
error message as follow:
"guvcview doesn't start: Fatal: g_thread NOT supported"
seems need to upgrade Guvcview 1.5.3 later.
I have the same problem
Posted: Thu 21 Feb 2013, 16:31
by mister_electronico
hikohan yes I have the same problem. I think maybe the incompatibility with GTK.
I am working with slacko 5.4 no precise.
But when I run command:
mplayer tv:// -tv driver=v4l2:width=768:height=450:device=/dev/video0 -fps 3
work ok.
Someone can give us any help.
Thanks.