Page 1 of 1
eth0 setting doesn't survive reboot
Posted: Mon 12 Nov 2012, 08:26
by splot
I set up eth0 using Nework Wizard with static address and it works fine. I cant use dynamic address.
The setting doesn't survive a reboot.
What am I doing wrong?
Lucid 528 and Slacko 531.
Thanks.
Re: eth0 setting doesn't survive reboot
Posted: Tue 13 Nov 2012, 17:14
by RetroTechGuy
splot wrote:I set up eth0 using Nework Wizard with static address and it works fine. I cant use dynamic address.
The setting doesn't survive a reboot.
What am I doing wrong?
Lucid 528 and Slacko 531.
Thanks.
I'm a little fuzzy -- but there was a thread some time back about this.
The problem is that your .rc file is getting copied-over from a master file. You need to modify the master file, so that's the one doing the copying-over...
I'll take a look when I get home and back on my Puppy machine.
Posted: Tue 13 Nov 2012, 18:22
by darkstrike
I was having this same problem on my Lupu 528 install on my tinker box but it seemed to solve itself and work properly again after 2 or 3 reboots....I didn't make any changes, so not sure what happened...?