(old)Puppy Linux Discussion Forum

Hi.

Someone gave me a main board Micro Star MS 7095 which I've successfully build into a small tower and connected to the power switch, so it runs by now - Intel Celeron, 2.93GHZ, 1GB RAM, 32MB Graphics Card, LazY Puppy, LiveFrugal from sda1.

But I would like to know where to connect the reset switch as well as the hd led etc.

Does anyone own such main board and can tell me where to connect these cables or sending a image (photo and description)?

I've searched Wikipedia for Micro Star MS 7095 --> results: 0 !!!

Thanks

RSH

Can you see some small writing by the pins, like pwr,reset, hdd led etc?
(might need a magnifying glass).
There is usually a number identifying Pin 1, so you can work your way through from that.

Don't search wikipedia, try:
https://duckduckgo.com/?q=Micro+Star+MS+7095+schematic
or:
https://duckduckgo.com/?q=Micro+Star+MS ... uct+manual
which leads to:
http://www.manualslib.com/manual/293466 ... tml?page=2

Yes!

This one did the trick! - everything is now connected as it should be!

Thanks a lot!!!