Same for me.bde wrote:WPA2 wireless setup in the first Puppy 4 Beta (398) is not being reused. Used Menu/Setup/Network Wizard. In Configure network interface for wlan0, setup wireless using WPA2, ran Test wlan0, ran Auto DHCP to get wireless connection (dhcp). [Note: During Wireless/wlan0 setup found error: Puppy Ethernet Wizard/Acquiring WPA connection/Unable to establish WPA connection. However, in the next screen, saw that testing of wlan0 was successful.] After acquiring Auto DHCP address, the message said
I said yes to this. Was able to connect to the internet and browse successfully. At the next boot, have to set this up again. This happens repeatedly. /etc/wpa_supplicant2.conf is correct (I see that my network ssid, psk, proto, key_mgmt, group in this file are correct.) Something else is wrong.CONFIGURATION OF wlan0 SUCCESSFUL!
Do you want to save this configuration? If you want to keep this configuration for next boot: click 'Yes'.
Happens since first alpha. Versions 2.xx and 3.xx no problems.
Using frugal install with ath pci driver for wireless network (pcmcia-card)
Tom