Do you mean TL-WN722N?TP-WN722N
Have you installed the PET that I linked to on the previous page for the Atheros wifi driver?
I have a TL-WN721N adapter that uses the same Atheros driver. I set up wlanmaker in Xenialpup and it's working for me.
So you do NOT see ath9k_htc?sancxjo wrote:ath9k_hw
Code: Select all
root# lspci | grep -i 'net'
01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 03)
02:00.0 Network controller: Qualcomm Atheros AR9285 Wireless Network Adapter (PCI-Express) (rev 01)
Code: Select all
wlan1 sancxjo none usb0
Code: Select all
root# wlanmaker wlan1 sancxjo none usb0
Configuration file: /tmp/hostapd.conf
Line 2: invalid/unknown driver 'rtl871xdrv'
1 errors found in configuration file '/tmp/hostapd.conf'
Failed to set up interface with /tmp/hostapd.conf
Failed to initialize interface
Code: Select all
root# lshw -class network
*-network DISABLED
description: Wireless interface
product: AR9285 Wireless Network Adapter (PCI-Express)
vendor: Qualcomm Atheros
physical id: 0
bus info: pci@0000:02:00.0
logical name: wlan0
version: 01
serial: 48:5d:60:7c:ca:f2
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=ath9k driverversion=4.4.95 firmware=N/A latency=0 link=no multicast=yes wireless=IEEE 802.11bgn
resources: irq:17 memory:febf0000-febfffff
Code: Select all
root# iwconfig wlan1
wlan1 unassociated Nickname:"<WIFI@REALTEK>"
Mode:Auto Frequency=2.412 GHz Access Point: Not-Associated
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
root# lsmod | grep cfg
cfg80211 206686 5 ath,ath9k_common,ath9k,mac80211,r8188eu
rfkill 12246 1 cfg80211